Description:

Fine workmanship, plastic, durable and has a long service life.
Large flow, stable performance and high efficiency, easy installation.
Install all the drill chucks, you can use the electric drill to get the pump, easy an convenient to use.
Compact and light weight design, portable and easy to store.
The recommended speed is 1500-3500 rpm. The pump head and flow are related to the speed. The higher the speed, the higher the head and flow.

Specification:

Color: black
Size: Approx. 106x37x64mm
Material: Plastic
Net Weight: Approx. 218g
Inner Tube Diameter: Approx. 15mm
Transmission Shaft Diameter: 8mm Round Shank
Working Temperature: Approx. 5-49℃(41-120℉)

Operation Instruction:
1. To achieve optimum priming and long service life, apply a few drops of lubricating oil in pump inlet prior to each use and flush with clean water after each use
2. Be sure inlet hose is airtight and as short as possible, inlet hose should not exceed 9FT(2.75m)
3. When pumping abrasive fluids or liquids with solids, using a strainer on the inlet line for longer service time
4. It is recommended that the pump is mounted to a surface for security and ease of use
5. Mount and start drill, observe whether the inlet pipe has a certain fluid that is sucked into the pump within 15-20 seconds. If not, check that inlet tube is properly mounted to inlet pump. Do not run dry, if pump fails to prime, check if the hose is kinked or clogged
6.Pumping speed is fast, can pump 25-30L water per minute(depends on the rpm of drill)

Package Includes:

1 Piece Drill Pump
2 Pieces Hose Clamp
1 Piece Connector

Note:

Please allow slightly measuring deviation due to manual measurement.