Description:

The frequency is 22.625MHz, can improve the stability of the machine after replacing the original crystal.

It is superior to the original module in different environments.
Suitable For Ya-esu FT-817/857/897 and other models for temperature-compensated crystal components, fully compatible with the original TCXO-9.
Actual test the frequency of the crystal is observed with a high-precision frequency meter.

The original crystal frequency is deflected with a fire-baked , but this temperature-compensated crystal has no obvious change, and the effect is remarkable.

Specification:

Material: Electronic component

Size: approx. 60x30x10mm/2.36x1.18x0.39inch.

Work Pressure: 10mbar to 1200mbar
Pressure: Absolute
Accurate: 1.5mbar
Output Type: Digital
Instllation: SMD/SMT
Plug Type: single
Connect Type: I2C, SPI
Resolution: 24Bit
Voltage: 3V
Max Work Temperature: +85°
Minimum Work Temperature: -40°
Max Voltage: 3.6V
Minimum Voltage: 1.8V

Package Includes:

1 Piece Compensated Crystal Module

Note:

The actual test frequency observed with precision frequency meter crystal , crystal original machine flew with fire frequency offset what happened , and this compensated crystal did not change significantly , the effect is significant
This crystal accuracy can be achieved 0.5PPM, consistent with the original TCXO-9 module parameters
Installation method:
Close the machine power supply, open the machine cover, find the location of the installation of removing crystal, need to machine with ordinary crystal pulling down first, then according to the alignment pins after plugging, installed boot does not require any Settings can begin to use